Panasonic DP-3510

745
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
1. Stapler Movement Controller
The Stapler Unit is moved by the Slide Motor (M8). Its home position is detected by the Slide Home
Position Sensor (PI18). The Stapler waits at the back irrespective of the staple mode and paper size.
After paper has been stacked on the Processing Tray, the Stapler is moved to the specified stapling
position in response to the stapling command from the Host Machine.
Fig. 2-030 shows the standby position of the Stapler and the stapling position depending on the staple
mode.
a. Front 1-Point Stapling
The Stapler waits at the back. The Stapler moves to and returns from the stapling position for each
stapling operation.
Fig. 2-030
b. Rear 1-Point Stapling
The Stapler waits at the back. The stapling position is the same as the standby position.
Fig. 2-031
Feed direction
Standby position
Stapling position
Stapler
Stopper
Feed direction
Standby position
Stapling position
Stapler
Stopper