Panasonic DP-3510

762
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
While two hole are being made, the 3-Hole Puncher makes a single round trip in escape direction
(moving up the Hole Puncher).
Fig. 2-054
3. Horizontal Registration Operation
The horizontal registration drive for the Punch Slide Unit is provided by the Horizontal Registration
Motor (M2P). The home position of the Punch Slide Unit is detected by the Horizontal Registration
Home Position Sensor (PI2P). The Punch Slide Unit detects the trailing edge of sheets using the
Trailing Edge Sensor (LED5, PT5) and the Horizontal Registration Sensors (LED1 through 4, SREG1
through 4), and causes a move to a specific position matching the trailing edge of each sheet (in
relation to the size of the sheet).
The horizontal registration operation takes place as follows:
1) When the leading edge of a sheet from the Host Machine is detected by the Trailing Edge Sensor
(LED5, PT5), the Horizontal Registration Motor (M2P) starts to move the Punch Slide Unit toward
the front.
Fig. 2-055
(Punch Shaft at Rest/
Home Position)
(Punch Shaft CCW Rotation by
90 /Punch at Upper Limit)
(Punch CCW Rotation by 180
/
Punch Back at Initial Position
)
Punch Slide Unit
Horizontal Registratio
n
Motor (M2P)
(Direction of
Paper Delivery)
T
railing Edge Sensor
(LED5, PT5)
Paper