804
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
3. After Replacing the EEP-ROM (IC1002)
1) Turn off the Host Machine.
2) Set bits 1 through 4 on the Punch Controller PCB as follows :
Fig. 5-007
3) Press SW1002 and SW1003 on the Punch Controller PCB at the same time.
• The presses will initialize the EEP-ROM. At the end, all LEDs (LED1001, LED1002, LED1003) will
go ON.
4) Adjust the sensor output, and store the number of punch holes.
ON
1234
To Next Page
Loading...
