Panasonic HL-G1 Series - Format; Value Setting

㻌
Ɣ Data Setting/Operation Instruction Command
Data setting/operation instruction command formats are used to make data
settings or give operating instructions.
Request communication data
Normal response data
㻌
Setting an average number of 256 times for sensor 02 in the RS-485
multi-mode.
Request communication data
㻌
Normal response data
FORMAT
ᵐᴾ
Value Setting
The following value setting command formats are used to set seven-digit
numeric values (measurement values and numeric values) with the decimal
point omitted.
Ɣ Read Command
Request communication data
Ex
ᴾ
BCC
% $ W
CR
Sender no. Command
% # W
s
Destination no. Command
BCC
CR
0 1 2 3 4
Data block: 1
-character symbol +
5
-character integral part (no zero suppress)
BCC
% # R
CR
Destination no. Command
% 0 2 $ W A V
CR
**
% 0 2 # W A V
+
CR
**0 0 0 0 4
Ramco Innovations
(
800
)
280-6933 www.panasonicsensors.com nsales
@
ramcoi.com