Panasonic HL-G1 Series - Digital Output at Alarm

 Digital Output at Alarm
㻌
This function is used to set the digital output status at alarm operation.
This function makes settings related to digital output (on the digital display block
of the sensor head and measurement values over serial communication) in the
alarm state (where measurement is disabled owing to lack of light). The digital data
will be set to +99999 if the fixed value is selected. The measurement value
immediately before the alarm will be displayed if the system is set to hold.
㻌
㻌
㻌
Selecting the fixed value can detect the alarm issued status easily from the
measurement result. With this convenient function, the alarm status can be
confirmed as well when the measurement value is loaded by data bufferin
g
function.
㻌
㻌
Setting Function Panel display
Hold
Holds the digital output
immediately before the alarm.
㻌
㻌
Fixed Value
Fixed-value output
㻌
㻌
* indicates the default value.
㻌
㻌

㻌
If the alarm state occurs after the fixed value is selected, judgment output
interlocked with digital output will be turned ON.
㻌
Ɣ6HWWLQJ3URFHGXUH
1
Display the "Alarm Setting" screen while
in setting mode.
㻌
2
3UHVVWKH>(17(5@NH\7KH$QDORJ
output at alarm" screen will be displayed.
㻌
3
3UHVVWKH>'2:1@NH\RQFH7KH'LJLWDO
output at alarm" screen will be displayed.
㻌
4
3UHVVWKH>(17(5@NH\7KHSUHVHQW
Hold/Fix will be displayed.
㻌
5
Press the [U3@>'2:1@NH\WRVHOHFW
Hold/Fix. (Example: Changing the
selection to the fixed value.)
㻌
6
3UHVVWKH>(17(5@NH\WRGHWHUPLQHWKH
set value.
Ramco Innovations
(
800
)
280-6933 www.panasonicsensors.com nsales
@
ramcoi.com