Panasonic HL-G1 Series - 3-3-4 Data Processing Settings; Average Times

3-3-4㻌 Data Processing Settings㻌
 Average Times㻌
㻌
This function is used to set the average number of times of moving average. Use
the function to stabilize unstable measurement values (including variations).
Setting Function Panel display
1 time
1-time moving average processing
㻌
㻌
4 times
4-time moving average processing
㻌
㻌
16 times
16-time moving average processing
㻌
㻌
64 times
64-time moving average processing
㻌
㻌
256 times
256-time moving average processing
㻌
㻌
1024 times
1024-time moving average processing
㻌
㻌
* indicates the default value.
㻌
㻌
Data unstability may result until the movement average buffer reaches the setting
number of times. When the data becomes unstable, the analog output, digital output
and judgment output will change.
㻌
(
㻌
refer to "2-5 Conditions When Output
Data Become Unfixed"). If there is an alarm when the moving average buffer is
cleared, moving averaging will start after the alarm state is cleared. Moving
averaging based on the previous data will be performed if an alarm occurs until the
setting number of times is reached after moving averaging starts.
㻌
Ɣ6HWWLQJ3URFHGXUH
㻌
1
Display the "Data Processing Setting"
screen while the system is in setting mode.
2
3UHVVWKH>(17(5@NH\7KH$YHUDJH
Times" screen will be displayed.
3
3UHVVWKH>(17(5@NH\7KHSUHVHQW
number of average times will be displayed.
㻌
4
3UHVVWKH>83@>'2:1@NH\WRFKDQJH
the number of average times.
(Example: Changing the number of
average times to 256.)
5
3UHVVWKH>(17(5@NH\DQGGHWHUPLQH
the number of average times.
Ramco Innovations
(
800
)
280-6933 www.panasonicsensors.com nsales
@
ramcoi.com