Panasonic HL-G1 Series - Sensor no

 Sensor No.㻌
㻌
This function is used to set the number of each sensor head multi connected
to an RS-485 device.
Be sure to set each connecting sensor head number with no duplication.
㻌
㻌
Setting range Function Initial value
01 to 16
Set sensor numbers 01 through
16 in sequence.
㻌
㻌
Ɣ6HWWLQJ3URFHGXUH
1
Display the "COM Setting" screen while
in setting mode.
㻌
2
3UHVVWKH>(17(5@NH\7KH
"Terminating Resistor Selection" screen
will be displayed.
㻌
3
3UHVVWKH>'2:1@NH\RQFH7KH
"Sensor No." screen will be displayed.
㻌
4
Press tKH>(17(5@NH\7KHSUHVHQW
sensor number will be displayed.
㻌
5
3UHVVWKH>83@>'2:1@NH\WRFKDQJH
the sensor number. (Example:
Changing the sensor number to 16.)
㻌
3UHVVWKH>83@>'2:1@NH\VWRJHWKHU
for at least 2 seconds to move the set
value at high speed.
㻌
6
3UHVVWKH>(17(5@NH\WRGHWHUPLQHWKH
sensor number.
Ramco Innovations
(
800
)
280-6933 www.panasonicsensors.com nsales
@
ramcoi.com