Panasonic HL-G1 Series - Mutual Interference Area

 Mutual Interference Area
In the case of installing two or more diffuse reflective sensor heads side by side,
mutual interference will occur if the laser spots of the other sensor heads fall within
the shaded area ( ) shown below. Install the sensor heads so that the laser spots
of the other sensor heads will fall outside the shaded area ( ).

Ɣ-mm Type (HL-G103-A-C5/HL-G103-S-J)
㻞
㻝㻜
㻟㻠
㻞㻢
㻢
㻢
㻝
㻝
㻝㻞㻚㻡
Unit: mm
Ɣ-mm Type (HL-G105-A-C5/HL-G105-S-J)
㻢㻜
㻠㻜
㻝㻠
㻝㻚㻡
㻝㻚㻡
㻤
㻝㻜
㻟
㻝㻞㻚㻡
Unit: mm
Ramco Innovations
(
800
)
280-6933 www.panasonicsensors.com nsales
@
ramcoi.com