Panasonic HL-G1 Series - Buffering Rate; Accumulated Amount

 Buffering Rate
㻌
The buffering rate can be set for accumulating the measurement data for a
ORQJGXUDWLRQE\WDNLQJDGHTXDWHVDPSOLQJF\FOHLQWHUYDOV
Select from 1 (all measurement data), 1/2, 1/4, etc. to 1/65535.
㻌
The buffering rate is set to “1/10” by default.
㻌
If 1/4 is selected for example, measurement data will be accumulated once every
four sampling cycles.
㻌
㻌
㻌
All measurement data can be accumulated. If measurement data deviation is
small at each sampling cycle, however, the duration of data accumulation longe
r
than that performed per sampling cycle can be set with an appropriat
e
accumulation interval of measurement data specified. This is useful for th
e
effective use of memory since the accumulated amount of data items is limited.
㻌
㻌
 Accumulated Amount
㻌
This function sets the accumulated amount of measurement data items.
This function sets the accumulated amount of measurement data items in a range of
1 to 3000.
㻌
The accumulated amount is set to “3000” by default.
㻌
㻌
Accumulation will not start unless the “trigger point” settings for the “accumulated
amount” of data items are correct.
㻌
Ramco Innovations
(
800
)
280-6933 www.panasonicsensors.com nsales
@
ramcoi.com