Panasonic HL-G1 Series - Offset

 Offset
㻌
A desired setting value can be added to/subtracted from the measurement value.
㻌
Measurement judgment will be possible from an offset in combination wit
h
“displacement judgment” by setting the size of the master workpiece
(reference measurement object) for the offset, measuring the master
workpiece, and turning the “zero set” ON.
㻌
Setting range Function
Initial value
-95000 to
+95000
-Set an offset in a range from 95000 to +95000.
㻌
(The decimal point position varies with each
model.
)
㻌
㻌
㻌
 Set "Offset" and turn "Zero Set" ON to make the setting value an offset value.
㻌
 The display limit of the measurement value is ±95000. Make sure that the setting
value does not exceed the display limit.
㻌
Ɣ6HWWLQJ3URFHGXUH
㻌
1
Display the "Data Processing Setting"
screen while the system is in setting mode.
㻌
2
3UHVVWKH>(17(5@NH\7KH$YHUDJH
Time" screen will be displayed.
㻌
3
3UHVVWKH>'2:1@NH\WKUHHWLPHV7KH
"Offset" screen will be displayed.
㻌
4
3UHVVWKH>(17(5@NH\7KHSUHVHQW
offset value will be displayed. The
leftmost digit will be selected.
㻌
5
3UHVVWKH>83@>'2:1@NH\VWRJHWKHUWR
change the selected digit. After all the
FKDQJHGGLJLWVKDYHEOLQNHGWKHVLJQFDQ
be changed. For details, refer to page 3-8
0DNLQJ6HWWLQJ9DOXH&KDQJHV
㻌
6
3UHVVWKH>83@>'2:1@NH\WRFKDQJH
the value of the selected digit or its sign.
(Example: Changing the value to
+2.500 [mm].)
㻌
7
3UHVVWKH>(17(5@NH\DQGGHWHUPLQH
the offset value.
Ramco Innovations
(
800
)
280-6933 www.panasonicsensors.com nsales
@
ramcoi.com