Panasonic HL-G1 Series - 3-3-10 Other System Settings; Initialize

3-3-10㻌Other System Settings㻌
 Initialize㻌
㻌
This function is used to delete all the setting contents in the memory and
returns them to the factory default settings.
㻌
㻌

㻌
When the initialization of the system is executed through the operation of the
panel, all settings will return to the factory default settings. When the
initialization of the system is executed through the operation of the panel, all
settings except COM settings and environment settings will return to the factory
default settings.
㻌

㻌
The initialized setting contents will not be saved if the system is initialized with
the communications command from the high-function type. To maintain the
initialized state after the system is turned OFF, be sure to execute the “Save”
command.

㻌
When the “initialization” is executed, the data unfixed status may occur
temporarily.
㻌
Ɣ6HWWLQJ3URFHGXUH
㻌
1
Turn ON the system while pressing the
>(17(5@NH\
The initial screen will be displayed after the
startup screen appears.
The memory is initialized and the system is
set to RUN mode.
㻌
+
Turn the power ON
Ramco Innovations
(
800
)
280-6933 www.panasonicsensors.com nsales
@
ramcoi.com