Panasonic HL-G1 Series - Buffering Operation; Status Readout; Last Data Point

 Buffering Operation㻌
㻌
This function accumulates data while the system is in buffering operation.
Set necessary parameters in advance and start buffering.
㻌
㻌

㻌
All settings related to buffering cannot be changed during buffering.
㻌

㻌
Non-buffering status cannot be set by only stopping buffering.
㻌
㻌
 Status Readout
㻌
This fuQFWLRQFKHFNVWKHVWDWXVRIPHDVXUHPHQWGDWDDFFXPXODWLRQ
Use this function for checking the accumulation status before reading out the
accumulated data. When the status is checked, the sensor head responds one of the
following conditions.
㻌
㻌
Status Details
Non-buffering
Buffering is not executed at all after turning on the power supply or
after initialization or buffering is stopped while waiting for the
trigger after buffering has started.
㻌
Wait for Tri
gg
er
Waiting for the trigger after buffering has started.
㻌
Accumulating
Buffering has started and measurement data is being accumulated or
trigger has been generated and measurement data is being
accumulated.
㻌
Accumulation
Completed
The accumulation amount has reached the setting value or buffering
has stopped.
㻌
㻌
㻌
 Last Data Point
㻌
The accumulation status can be read out from the data amount.
The "Final Data Point" will be set to "0" when the "Status Readout" is set to
Non-buffering or Wait for Trigger.
㻌
㻌
Ramco Innovations
(
800
)
280-6933 www.panasonicsensors.com nsales
@
ramcoi.com