Panasonic HL-G1 Series - Connection Mode

 Connection Mode㻌
㻌
This function is used to select the performance settings for measurement
data output to the host device.
Select the operation settings for measurement data output to the host device.
㻌
This section provides information on the condition that the RS-422 device is
connected 1-to-1 and the RS-485 device is connected 1-to-N (sensor heads) to the
system. For the connection method,
㻌
refer to "4-1 Communications
Specifications - Connecting Example with External Device." For details of the
dedicated output format,
㻌
refer to "4-2 Type and Format of Commands".
㻌
㻌
Setting
Connection
method
Function
Panel
displa
y
RS-422
KDQGVKDNH
RS-422
Transmits the result data (a response command)
in response to a request command from the host
device. All commands can be received.
㻌
㻌
RS-422
Timing
Transmits the measured value in the exclusive
output format when timing input is ON while
the system is in this mode.
㻌
㻌
RS-422
Continuous
Transmits the measured value continuously in
the exclusive output format after this mode is
selected.
㻌
㻌
RS-485
Multiple
RS-485
Up to 16 sensor heads are connected to the
host device. Transmits the result data (a
response command) in response to a request
command from the host device. No sensors
outside the designated range will not respond.
㻌
㻌
* indicates the default value.
㻌
Ɣ6HWWLQJ3URFHGXUH
1
Display the "COM Setting" screen while
in setting mode.
㻌
2
3UHVVWKH>(17(5@NH\7KH7HUPLQDWLQJ
Resistor Selection" screen will be displayed.
㻌
3
3UHVVWKH>'2:1@NH\WKUHHWLPHV7KH
"Connection Mode" screen will be displayed.
㻌
4
3UHVVWKH>(17(5@NH\7KHSUHVHQW
connection mode will be displayed.
㻌
5
3UHVVWKH>83@>'2:1@NH\WRFKDQJHWKH
connection mode. (Example: Changing the
connection to RS-485 multi connection.)
㻌
6
3UHVVWKH>(17(5@NH\WRGHWHUPLQHWKH
connection mode setting.
㻌
Ramco Innovations
(
800
)
280-6933 www.panasonicsensors.com nsales
@
ramcoi.com