(1) RUN mode
㻌
The measurement value will appear on the digital display in this mode.
㻌
The system will be set to this mode when the system is turned ON.
㻌
RS-422/485 write and read commands will be received while the system is in
this mode.
㻌
(2) Setting mode
㻌
Use this mode to make setting changes.
㻌
RS-422/485 write commands cannot be received while the system is in this
mode.
㻌
An error code indicating that the system is in setting mode will be returned if a
write command is received.
㻌
Refer to the next page for the transition of the screen while the system is in
setting mode.
㻌
(3) Zero set
㻌
The measurement value will be set to zero in this mode.
㻌
(4) Reset
㻌
The measured value kept on hold by the system in measurement mode will be
reset.
㻌
(5) Threshold a
㻌
The screen will change to the threshold-a setting screen.
㻌
(6) Threshold b
㻌
The screen will change to the threshold-b setting screen.
㻌
(7) Initialization
㻌
Initialization deletes all settings and returns them to the factory default settings.
㻌
㻌
㻌
Setting changes in the control panel of the sensor head will be saved in the
internal memory.
㻌
㻌
Ramco Innovations
800
280-6933 www.panasonicsensors.com nsales
ramcoi.com
To Next Page
Loading...
