Panasonic HL-G1 Series - Page 50

㻌
*1 Not displayed when "Voltage" is selected for "Analog Output Selection."
㻌
*2 Not displayed when "Current" is selected for "Analog Output Selection."
㻌
㻌
㻌
㻌
㻌
A
nalog output selection
Measurement value A
Current a *1
Voltage a *2
Measurement value B
Current b *1
Voltage b *2
A
nalog output at alarm
Digital output at alarm
A
larm delay times
Terminating resistor selection
Sensor no.
Baud rate
Connection mode
Timing mode
Laser control
Eco mode
View version
3UHVVLQJWKH>(17(5@NH\DWOHDVWV
will determine the set value at any level
and go into RUN mode.
2 s
Run mode Setting mode
Analog settings
Alarm settings
COM settings
System settings
Sending delay times
Ramco Innovations
(
800
)
280-6933 www.panasonicsensors.com nsales
@
ramcoi.com