Panasonic HL-G1 Series - Page 64

㻌
OUT3 settings are related to the operation of the output lines. An alarm is output through
the OUT3 output line unless a 3-state value has been set. The OUT3 indicator on the sensor
head and the OUT3 output readout function, however, will be turned OFF without being
interlocked with the alarm. Check the alarm state with the alarm indicator and alarm
readout function.
Ɣ6HWWLQJ3URFHGXUH
㻌
1
Display the "Output Setting" screen while
the system is in setting mode.
2
3UHVVWKH>(17(5@NH\7KH-XGJPHQW
Output Selection" screen will be
displayed.
3
3UHVVWKH>(17(5@NH\7KHSUHVHQW
output type will be displayed.
㻌
4
3UHVVWKH>83@>'2:1@NH\WRPDNH
output type changes. (Example:
Changing the output type to
"Independent.")
5
3UHVVWKH>(17(5@NH\WRGHWHUPLQHWKH
output type.
Ramco Innovations
(
800
)
280-6933 www.panasonicsensors.com nsales
@
ramcoi.com