Panasonic HL-G1 Series - Page 72

㻌

㻌
The display limit of the measurement value is ±95000. Make sure that the setting
value does not exceed the display limit.
㻌

㻌
Check the input range of your input device such as AD board before setting.
㻌

㻌
The decimal point position of measurement values varies with each model.
㻌
㻌
㻌
Ɣ6HWWLQJ3URFHGXUH
㻌
Setting current a (current for measurement value A)
㻌
1
Display the "Analog Setting" screen
while in setting mode.
2
3UHVVWKH>(17(5@NH\ The "Analog
Output Selection" screen will be
displayed.
㻌
3
3UHVVWKH>'2:1@NH\WZLFH7KH
"Current a" screen will be displayed.
4
Press WKH>(17(5@NH\7KHSUHVHQWVHW
value will be displayed. The leftmost digit
will be selected.
5
3UHVVWKH>83@>'2:1@NH\VWRJHWKHUWR
change the selected digit. After all the
FKDQJHGGLJLWVKDYHEOLQNHGWKHVLJQFDQ
be changed. For details, refer to page 3-8
0DNLQJ6HWWLQJ9DOXH&KDQJHV
6
3UHVVWKH>83@>'2:1@NH\WRFKDQJHWKH
value of the selected digit. (Example:
Changing the value to 5.000 [mA].)
7
3UHVVWKH>(17(5@NH\WRGHWHUPLQHWKH
set value.
㻌
Ramco Innovations
(
800
)
280-6933 www.panasonicsensors.com nsales
@
ramcoi.com