To remove a card from the PBX
1. Move the mouse pointer over the card to remove.
A menu will be shown under the mouse pointer.
2. Select Delete.
3. Click Yes to confirm.
The card will be removed.
To change the status (INS/OUS) of a card (Interactive mode only)
1. Move the mouse pointer over the card.
A menu will be shown under the mouse pointer.
2. Select the desired status:
• Click INS to set the card to in-service status.
• Click OUS to set the card to out-of-service status.
To install an option card on an OPB3 card
1. Move the mouse pointer over the card.
A menu will be shown under the mouse pointer.
2. Select Option Card.
The OPB3 Option Card Setup screen will be displayed. See 3.60 [1-1] Slot—OPB3 Option Card
Setup.
To access IP-PT port properties
1. Click the IP Phone Registration button.
Supported Card Types
KX-NCP500/KX-NCP1000
Card Maximum Quantity Card Programming
IPCMPR: IP Convergence Main
Processing Card
1 (fixed)
3.4 [1-1] Slot—Card Property -
IPCMPR (for KX-NCP500/
KX-NCP1000/KX-TDE100/
KX-TDE200)/IPCEMPR (for
KX-TDE600)
DHLC4: 4-Port Digital Hybrid
Extension Card
KX-NCP500: 1
KX-NCP1000: 1
3.23 [1-1] Slot—Card Property -
Extension Type
DLC8: 8-Port Digital Extension Card
KX-NCP500: 1
KX-NCP1000: 2
DLC16:
16-Port Digital Extension Card
SLC8: 8-Port Single Line Telephone
Extension Card
SLC16:
16-Port Single Line Telephone
Extension Card
LCOT4: 4-Port Analogue Trunk Card KX-NCP500: 3
KX-NCP1000: 4
3.29 [1-1] Slot—Card Property -
LCO type
PC Programming Manual 109
3.1 [1-1] Slot
To Next Page
Loading...
