Panasonic KX-NCP500 Programming Manual

2.1.4 Card Status
Certain
tools, utilities and settings require that the target card be set to out-of-service (OUS) or in-service (INS)
status before the operation is carried out. Where required, this is noted in the description of each item. Card
status changes can only be performed when the software is in Interactive mode (see 2.1.1 Starting
Maintenance Console and Software Modes).
• "In service" means that the card is installed correctly in the PBX, and is capable of being used normally.
• "Out of service" means that the card is installed correctly in the PBX, but has been temporarily removed
from use. This allows settings to be modified or software to be upgraded.
• "Fault" means that the card is not installed in the PBX correctly, or is not functioning correctly. For more
information, see the Installation Manual.
For details about how to change the status of a card, see To change the status (INS/OUS) of a card
(Interactive mode only) on screen 3.1 [1-1] Slot.
34 PC Programming Manual
2.1.4 Card Status

Panasonic KX-NCP500 Specifications

General

VoIP Support	Yes
Operating System	Proprietary
Type	Hybrid IP-PBX
VoIP Codecs	G.711, G.729A
Protocols	SIP, H.323
Operating Temperature	0°C to 40°C
Analog Extensions	Yes
IP Extensions	Yes
Power Supply	AC 100-240 V, 50/60 Hz
SIP Trunks	Yes
Wireless (DECT) Extensions	Yes, with optional module
Weight	4.0 kg
Humidity	20% to 80% (non-condensing)