Panasonic KX-NCP500 - 1-1] Slot-Port Property - EM Port-Connection Command (KX-TDE Series Only)

3.48 [1-1] Slot—Port
Property - EM Port—Connection
Command (KX-TDE series only)
Commands for the E & M channels can be programmed.
INS
Puts the channel in service.
Value Range
Not applicable.
Maintenance Console Location
3.48 [1-1] Slot—Port Property - EM Port—Connection Command (KX-TDE series only)
Programming Manual References
3.47 [1-1] Slot—Port Property - EM Port (KX-TDE series only)
Feature Guide References
None
OUS
Takes the channel out of service. This enables a temporary non-use of the channel, for example, for the
purpose of repair.
Value Range
Not applicable.
Maintenance Console Location
3.48 [1-1] Slot—Port Property - EM Port—Connection Command (KX-TDE series only)
Programming Manual References
3.47 [1-1] Slot—Port Property - EM Port (KX-TDE series only)
Feature Guide References
None
PC Programming Manual 413
3.48 [1-1] Slot—Port Property - EM Port—Connection Command (KX-TDE series only)