Panasonic KX-NCP500 - 1-1] Slot-Card Property - DID Type (KX-TDE Series Only)

3.49 [1-1] Slot—Card Property - DID type (KX-TDE
series only)
The property for the DID card can be specified.
First Dial Timer
Specifies
the minimum time that the PBX waits after seizing a DID line, before sending the dialled digits to the
telephone company or to another PBX. This allows the telephone company or the other PBX to have enough
time to accept the dialled digits correctly.
Value Range
32 ´ n (n=1–255) ms
Maintenance Console Location
3.49 [1-1] Slot—Card Property - DID type (KX-TDE series only)
Programming Manual References
None
Feature Guide References
None
DTMF Tone—DTMF Inter-digit Pause
Specifies the length of the DTMF inter-digit pause. This allows the telephone company to have enough time
to accept the dialled digits correctly.
Value Range
64 + 16 ´ n (n=0–11) ms
Maintenance Console Location
3.49 [1-1] Slot—Card Property - DID type (KX-TDE series only)
Programming Manual References
None
Feature Guide References
None
Pulse Dial—Pulse % Break
Specifies
the % break for pulse digits. This is the ratio between the break (on-hook) signal and make (off-hook)
signal in a pulse dial.
414 PC Programming Manual
3.49 [1-1] Slot—Card Property - DID type (KX-TDE series only)