2.6.22 Utility—System Reset—Reset by the Command
Updates
the main system programme and data files stored within the PBX using files taken from the SD memory
card, and resets the connected PBX.
This option is only available at Installer level.
Two copies of each of the main system files can be stored on the SD memory card. The names of these files
are as follows:
KX-NCP500/KX-NCP1000
File Name Description
DBSYS Main system data file. Contains all of the current configuration data for
the PBX.
DBSYS_S Backup main system data file
PBMPR PBX programme file. Contains the software to run the IPCMPR board
of the PBX.
PBMPR_S Backup PBX programme file
KX-TDE100/KX-TDE200
File Name Description
DMSYS Main system data file. Contains all of the current configuration data for
the PBX.
DMSYS_S Backup main system data file
PMMPR PBX programme file. Contains the software to run the IPCMPR board
of the PBX.
PMMPR_S Backup PBX programme file
KX-TDE600
File Name Description
DGSYS Main system data file. Contains all of the current configuration data for
the PBX.
DGSYS_S Backup main system data file
PGMPR PBX programme file. Contains the software to run the IPCEMPR
board
of the PBX.
PGMPR_S Backup PBX programme file
When new DBSYS/DMSYS/DGSYS
and PBMPR/PMMPR/PGMPR files are transferred from a connected PC
to the SD memory card using the File Transfer PC to PBX (SD Card) utility (see 2.6.2 Utility—File Transfer
PC to PBX (SD Card)), they are stored as the backup files. To use these files on the PBX, it is necessary to
first swap them with the currently active files on the SD memory card.
To update system files and reset the PBX
1. From the Utility menu, point to System Reset and then click Reset by the Command.
2. Choose whether to back up current system data or not.
• Click SD Backup to back up the current system data to the SD memory card before proceeding.
94 PC Programming Manual
2.6.22 Utility—System Reset—Reset by the Command
To Next Page
Loading...
