Panasonic KX-NCP500 - Page 137

DSP CODEC G.711 only (IP-GW)
Specifies whether or not to only use the G.711 codec for IP trunk calls.
Value Range
Enable, Disable
Maintenance Console Location
3.4
[1-1] Slot—Card Property - IPCMPR (for KX-NCP500/KX-NCP1000/KX-TDE100/KX-TDE200)/IPCEMPR
(for KX-TDE600)
Programming Manual References
3.11 [1-1] Slot—Shelf Property - Virtual IP Gateway—GW Settings
Feature Guide References
None
DSP CODEC Priority-1 value only (others)
Specifies whether or not to only use the priority 1 codec set for the following types of calls:
• IP extension calls
• SIP trunk calls
Value Range
Enable, Disable
Maintenance Console Location
3.4
[1-1] Slot—Card Property - IPCMPR (for KX-NCP500/KX-NCP1000/KX-TDE100/KX-TDE200)/IPCEMPR
(for KX-TDE600)
Programming Manual References
3.15 [1-1] Slot—Port Property - Virtual IP Extension
3.21 [1-1] Slot—Port Property - Virtual IPCS
Feature Guide References
None
Port Number
Maintenance Port Number
Specifies the port number used to operate Maintenance Console via the LAN.
Value Range
1–65535
PC Programming Manual 137
3.4 [1-1] Slot—Card Property - IPCMPR (for KX-NCP500/KX-NCP1000/KX-TDE100/KX-TDE200)/IPCEMPR (for
KX-TDE600)