Panasonic KX-NCP500 - Page 214

Value Range
1024–65535
Maintenance Console Location
3.20 [1-1] Slot—Card Property - Virtual IPCS
Programming Manual References
None
Feature Guide References
None
Voice (RTP) UDP Port No. (Server)
Specifies the UDP port used by the V-IPCS card to transmit and receive RTP (Realtime Transfer Protocol)
data. This must be changed if another network application is using the same port.
For voice communications, the V-IPCS card uses 128 contiguous UDP ports, starting from the port number
specified here.
To change the value displayed here, click Common Settings and set the desired value.
Value Range
1024–65024
Maintenance Console Location
3.20 [1-1] Slot—Card Property - Virtual IPCS
Programming Manual References
None
Feature Guide References
None
Voice (RTP) UDP Port No. (IP-CS)
Specifies the UDP port used to transmit and receive RTP (Realtime Transfer Protocol) data on the IP-CS side.
This must be changed if another network application is using the same port.
For voice communications, an IP-CS uses 128 contiguous UDP ports, starting from the port number specified
here.
To change the value displayed here, click Common Settings and set the desired value.
Value Range
1024–65024
214 PC Programming Manual
3.20 [1-1] Slot—Card Property - Virtual IPCS