Pulse / DTMF Dial—DTMF Inter-digit Pause
Specifies the length of the DTMF inter-digit pause. This allows the telephone company to have enough time
to accept the dialled digits correctly.
Value Range
64 + 16 ´ n (n=0–11) ms
Maintenance Console Location
3.29 [1-1] Slot—Card Property - LCO type
Programming Manual References
None
Feature Guide References
None
Pulse / DTMF Dial—Pulse Inter-digit Pause
Specifies
the length of the pulse inter-digit pause. This allows the telephone company to have enough time to
accept the dialled digits correctly.
Value Range
630 ms, 830 ms, 1030 ms
Maintenance Console Location
3.29 [1-1] Slot—Card Property - LCO type
Programming Manual References
None
Feature Guide References
None
Low Speed Pulse Dial—Pulse % Break
Specifies
the % break for a low speed pulse dial. This is the ratio between the break (on-hook) signal and make
(off-hook) signal in a pulse dial.
Value Range
Other, 60 %, 67 %
Maintenance Console Location
3.29 [1-1] Slot—Card Property - LCO type
PC Programming Manual 251
3.29 [1-1] Slot—Card Property - LCO type
To Next Page
Loading...
