Panasonic KX-NCP500 - Page 360

Programming Manual References
None
Feature Guide References
None
Flash—Flash Detection
Enables the PBX to detect a hookswitch flash signal sent from an
E1 line.
Value Range
Disable, Enable
Maintenance Console Location
3.40 [1-1] Slot—Card Property - E1 type
Programming Manual References
None
Feature Guide References
None
Flash—Minimum BREAK Width
Specifies the minimum length of the break signal in a flash signal sent from an
E1 line.
Value Range
8 ´ n (n=3–63) ms
Maintenance Console Location
3.40 [1-1] Slot—Card Property - E1 type
Programming Manual References
None
Feature Guide References
None
Flash—Flash Width
Specifies
the maximum length of a flash signal sent from an E1 line that the PBX can recognise as a hookswitch
flash signal.
360 PC Programming Manual
3.40 [1-1] Slot—Card Property - E1 type