Value Range
Max. 8 digits (0–9, *, and #)
Maintenance Console Location
5.3 [3-1-3] Caller ID Modification
Programming Manual References
3.35 [1-1] Slot—Port Property - PRI Port— Calling Party number—Type of Number—Public, Private
3.35 [1-1] Slot—Port Property - PRI Port— Called Party number—Type of Number—Public, Private
Feature Guide References
1.18.1 Caller ID
CLIP
When
incoming caller information is sent through an ISDN line and the type of the network numbering plan is
International, National, or Subscriber, the caller’s number can be modified as programmed in the Modification
Tables assigned to the trunk group. The modified number will then be recorded, and it is used for sending to
the network as a CLIP number.
A maximum of 4 CLIP Modification Tables can be programmed. Select the desired table from the Modification
Table list.
Removed Number of Digits
Specifies the number of leading digits to be removed from the incoming caller’s number for each type of network
numbering plan.
Value Range
0–9
Maintenance Console Location
5.3 [3-1-3] Caller ID Modification
Programming Manual References
3.35 [1-1] Slot—Port Property - PRI Port—
Calling Party Number—Type of Number—Public, Private
3.35 [1-1] Slot—Port Property - PRI Port—
Called Party Number—Type of Number—Public, Private
Feature Guide References
1.18.1 Caller ID
Added Number
Specifies the number to be added to the incoming caller
’s number in the place of the removed digits for each
type of network numbering plan.
608 PC Programming Manual
5.3 [3-1-3] Caller ID Modification
To Next Page
Loading...
