Optional Parameter (Ringing Tone Type Number) (for Time Service)
Specifies the Time Table to be used for changing time modes in the Automatic Switching mode.
Value Range
For KX-NCP500/KX-NCP1000
/KX-TDE100/KX-TDE200:
1–8
For KX-TDE600:
1–32
Maintenance Console Location
6.5 [4-1-4] Wired Extension—Flexible Button
Programming Manual References
None
Feature Guide References
2.2.4 Time Service
Optional Parameter (Ringing Tone Type Number) (for Loop CO, Single CO,
Group CO, ICD Group
, SDN)
Specifies the ring tone type.
Value Range
KX-DT300 series (except KX-DT321)/KX-T7600 series (except KX-T7665)/IP-PT (except KX-NT265/
KX-NT321): 1–30
KX-DT321/KX-T7665/KX-NT265/KX-NT321: 1–8 (Even if ring tone 9–30 is selected, ring tone 1 is heard.)
Other telephones: 1–8 (Even if ring tone 9–30 is selected, ring tone 2 is heard.)
Maintenance Console Location
6.5 [4-1-4] Wired Extension—Flexible Button
Programming Manual References
None
Feature Guide References
None
Optional Parameter (Ringing Tone Type Number) (for Call Park)
Specifies
the number of the parking zone a call is to be parked in when a Call Park button with
Parameter
Selection (for Call Park) on this screen set to Specific is pressed.
PC Programming Manual 727
6.5 [4-1-4] Wired Extension—Flexible Button
To Next Page
Loading...
