Panasonic KX-NCP500 - Page 822

Value Range
Fixed: The number of times of a tone pattern (a set of tone-on and tone-off) that the PBX receives is fixed to
4 times in the ranges of:
A
B
C
D
C
C
D D
, = 100–1300 ms, = 90 ms, = 90 ms
Option: The tone pattern that the PBX receives is optional as specified in DISA Cyclic Tone Option on this
screen.
Maintenance Console Location
7.3 [5-3-1] Voice Message—DISA System
Programming Manual References
3.58 [1-1] Slot—OPB3 Card Property
Feature Guide References
None
DISA Cyclic Tone Option—Tone On Maximum Time
Specifies the maximum duration of the cyclic tone that will be recognised by the PBX. When the tone sent from
the telephone company is shorter than the value set here, the PBX recognises it as a tone-on.
Note that this option can only be set when DISA Cyclic Tone Detection on this screen is set to "Option".
To apply changes to this setting, follow the steps below:
1. Change this setting.
2. Set the status of the OPB3 card to "OUS", then "INS".
Value Range
10 ´ n (n=11–400) ms
Maintenance Console Location
7.3 [5-3-1] Voice Message—DISA System
Programming Manual References
3.1 [1-1] Slot
3.58 [1-1] Slot—OPB3 Card Property
Feature Guide References
None
822 PC Programming Manual
7.3 [5-3-1] Voice Message—DISA System