Panasonic KX-NS1000 - Page 223

Connection Mode setting Additional settings
Static IP
• WAN IP Address
*1
• Subnet Mask
*2
• Gateway
*1
• Preferred DNS IP Address
*1
• Alternative DNS IP Address
*1
DHCP
• If you select Obtain From DHCP in DNS Setting,
address information is obtained from the DHCP
server.
• If you select Static in DNS Setting specify the
following settings:
– Preferred DNS IP Address
*1
– Alternative DNS IP Address
*1
PPPoE Refer to "PPPoE Additional Settings".
Disable The built-in router does not operate
PPPoE Additional Settings
Specify the following settings:
Settings
Address Conf. Mode
Dynamic IP Unnumbered Static IP
User Name
*3
ü ü ü
Password
*3
ü ü ü
Service Name
*4
ü ü ü
WAN IP Address
*1
ü ü
Subnet Mask
*2
ü
Gateway
*1
Preferred DNS IP Address
*1
ü
Alternative DNS IP Address
*1
ü
Note
• For details about configuring the parameters, refer to
"27.2.1 Router
Configuration—Setup—[1-2-1] WAN—Connection Settings" in the PC Programming Manual.
• For details about the values to set for the parameters, consult the network administrator.
c. In IPSec (VPN) Connection (Trial Activation Key), select Simple Configuration –VPSS.
Note
• The
IPSec feature will operate until the trial activation key expires. To continue using the IPSec
feature, the activation key (KX-NSN216) is required.
• For details about manually changing parameters related to inter-site connections via IPSec
established by VPSS, refer to "27.9 Router Configuration—VPN—[3-1] VPSS" in the PC
Programming Manual.
Installation Manual 223
5.4.1 Easy Setup Wizard