To set the DS field value for the primary port
To set the DS field value for the secondary port (only for KX-NT300 series)
To start programming
Press PROGRAM while
"Searching" is displayed.
Select "QoS". Select "Diffserv".
To end programming
Press STORE.
Press HOLD until the
Menu screen is displayed.
Select "Primary Port".
Diffserv
0.0–7.7
Press SP-PHONE. Press SP-PHONE.
Select "DS (Enable)".Press SP-PHONE. Press SP-PHONE.
Press SP-PHONE.
Press HOLD to return to
the Diffserv setting screen.
Select "Secondary Port". Select "DS (Enable)".Press SP-PHONE.
Press SP-PHONE.
Press SP-PHONE.
Diffserv
0.0–7.7
The IP-PT will reboot
and can then be
registered to the PBX.
To Next Page
Loading...
