Panasonic KX-NS1000 - 3.2.2.4 Autoplay New Message; 3.2.2.5 Bookmark

Application LAN Side Port Number WAN Side Port Number
RTP (UDP) Start/End RTP (UDP) Port No.
(Use port numbers that are in the
range of the RTP ports that the
KX-NS1000 uses.)
*1
Start/End RTP (UDP) Port No.
(Use port numbers that are in the
range of the RTP ports that the
KX-NS1000 uses.)
*1
Make sure the RTP Start Port (UDP)
and the RTP End Port (UDP) specified
for the router are in the range of the RTP ports that the KX-NS1000 uses.
For the range of RTP port numbers that the KX-NS1000 uses, refer to "Port
Numbers for Optional DSP Cards" in "8.5 Port Security".
*1
FTP The port number used for the FTP
protocol. This is used for software
updates.
NAT - FTP Server Port No.
(Use the same value as in step 5 of
"Programming the KX-NS1000 with
Built-in Media Relay Gateway
".)
*1
The port number ranges must be within the range of RTP/RTCP for NAT traversal
(16000–18047).
Up to 4 IP addresses can be assigned to the KX-NS1000's optional DSP cards. The following example shows the port number ranges
set for each IP address:
[Example]
Port forward destination Port number range
DSP#1–1 16000–16511
DSP#1–2 16512–17023
DSP#2–1 17024–17535
DSP#2–2 17536–18047
For the IP-CS (KX-NS0154 only):
Application LAN Side Port Number WAN Side Port Number
PTAP Signalling (PTAP) UDP Port No.
(Server)
(refer to PC Programming Manual
"9.18 PBX Configuration—[1-1]
Configuration
—Slot—V-IPCS4
—Card Property")
Signalling (PTAP) UDP Port No.
(Server)
(refer to PC Programming Manual
"9.18 PBX Configuration—[1-1]
Configuration—Slot—V-IPCS4
—Card Property")
MGCP Signalling (MGCP) UDP Port No.
(Server)
(refer to PC Programming Manual
"9.18 PBX Configuration—[1-1]
Configuration
—Slot—V-IPCS4
—Card Property")
NAT - MGCP Server Port No. for
IP-CS
(Use the same value as in step 5 of
"Programming the KX-NS1000 with
Built-in Media Relay Gateway".)
RTP (UDP) Start/End RTP (UDP) Port No.
(Use port numbers that are in the
range of the RTP ports that the
KX-NS1000 uses.)
*1
Start/End RTP (UDP) Port No.
(Use port numbers that are in the
range of the RTP ports that the
KX-NS1000 uses.)
*1
Make sure the RTP Start Port (UDP) and the RTP End Port (UDP) specified
for the router are in the range of the RTP ports that the KX-NS1000 uses.
For the range of RTP port numbers that the KX-NS1000 uses, refer to "Port
Numbers for Optional DSP Cards" in "8.5 Port Security".
*1
298 Installation Manual
5.9.4 Installing IP Phones at a Remote Site with a Built-in Media Relay Gateway