Station Programming
User Manual 105
— Using the Jog Dial (With a KX-T7431 / KX-T7433 / KX-T7436 only)
See Combination Table 2.
1) Press 6 and then rotate the Jog Dial one pulse to enter "M."
2) Press 4 and then rotate the Jog Dial six pulses to enter "i."
3) Press 5 and then rotate the Jog Dial four pulses to enter "k."
4) Press 3 and then rotate the Jog Dial four pulses to enter "e."
OR
1) Press 2 and then rotate the Jog Dial until "M" appears.
2) Press 2 and then rotate the Jog Dial until "i" appears.
3) Press 2 and then rotate the Jog Dial until "k" appears.
4) Press 2 and then rotate the Jog Dial until "e" appears.
Notes
• Pressing the SHIFT button alternates between capital and lower case letters. Once this
button is pressed, that letter SHIFT mode remains until SHIFT is pressed again.
• To erase the last character (to backspace), press the CONF button.
(The CONF button becomes the " " (backspace) key when using the overlay.)
• To erase the line, press CLR (S2) button or TRANSFER button.
• If you keep rotating the Jog Dial, all of the characters will be displayed in order.
<Example> If you rotate the Jog Dial after pressing 2, all of the characters will appear
in the following order:
A a B b Z z (space) ! ? . , ' : ; / + – = < > # $ % & @ ( ) A a B b
Conditions
• The default is "Not Stored."
• Up to 10 dialing numbers and names can be assigned. Each dialing number has a maximum
of 24 digits and each name has a maximum of 10 characters.
• The number can be an extension number, telephone number or a feature number.
• To store the telephone number of an outside party, a line access code (9, or 801 through 848)
must be stored as the leading digit.
• You can use 0 through 9, , #, PAUSE, FLASH, CONF and INTERCOM for storing.
FLASH: hook flash
PAUSE: pause
CONF: — (hyphen)
INTERCOM: for secret dialing
... ...
To Next Page
Loading...
