Station Programming
User Manual 95
2.2.13 Ringing Tone Selection for CO Buttons
Allows you to assign a ringer frequency to each CO (S-CO, G-CO, L-CO) or DN (PDN, SDN)
button.
— Be sure that you are in the Station Programming mode: Press [PROGRAM] [9] [9].
— To exit the Station Programming mode: Press [PROGRAM].
Conditions
• The default is Ringing Tone Type 2.
• This feature applies to the following line access buttons:
S-CO, G-CO, L-CO, PDN, SDN
Press CO, PDN or SDN
which you wish to
change the ringing tone.
Press STORE.
Press the same CO,PDN
or SDN again.
Enter the tone type number
(1 through 8).
tone type no.
AUTO DIAL
STORE
The display shows the current
status.
The display shows the selected tone type number and you hear
the selected tone until the STORE button is pressed.
<DPT Display Example>
(-x:tone type number)
If you want to change the tone type, enter another tone type
number.
Tone Type-X
DPT
The STORE indicator lights.
The display shows the initial
programming mode.
To Next Page
Loading...
