User Programming
112 User Manual
3.1.2 Programming Methods
Advancing to the next stage
When "SYS-PGM NO? " is displayed, you can select one of the following:
• To go to program [000], press the NEXT button.
• To go to another program, enter the 3-digit program address.
Entering Characters
You can enter characters to store names for speed dial numbers, extension numbers, etc., by
using the dialing key pad and buttons.
Each of the twelve dialing keys on the dialing key pad represents seven characters. Please refer
to Section "2.2.17 Station Speed Dialing Number/Name Assignment [KX-T7235/KX-
T7431/KX-T7433/KX-T7436 only]."
Storing your data
Press STORE to store your data.
• The STORE indicator lights in red and a confirmation tone sounds.
*Confirmation tone (one beep)
After pressing STORE, you will hear a beep. This informs you that storage is completed.
*Alarm tone (three beeps)
If you hear this alarm, your entry is not valid.
Making another selection within the same program address
• To go to the next selection, press NEXT.
• To go to the previous selection, press PREV.
• To make a specific selection, press SELECT and then enter the number.
To Next Page
Loading...
