User Programming
User Manual 113
Accessing another program address
After pressing STORE, you can access another program by one of the following two methods:
a) To go to the next program address:
• Higher program address
<KX-T7200 series>
Press Soft 1 (SKP+) or VOLUME (DOWN).
<KX-T7400 series>
Rotate the Jog Dial clockwise.
• Lower program address
<KX-T7200 series>
Press SHIFT + Soft 1 (SKP-) or VOLUME (UP).
<KX-T7400 series>
Rotate the Jog Dial counterclockwise.
b) To go to a specific program address:
Press END, then enter the program address.
Returning to the operation mode
When the Initial Message: SYS-PGM NO? is displayed, press the PROGRAM button.
(To display the Initial Message, press END.)
To Next Page
Loading...
