Station Programming
92 User Manual
2.2.12 Preferred Line Assignment — Outgoing
Allows you to select the desired outgoing line preference to originate calls from the following
three line preferences:
a) No Line Preference
b) Idle Line Preference
c) Prime Line Preference (INTERCOM) (— default
*1
)
Follow the programming procedure according to your selection.
Note
• If "Idle Line Preference," "No Line Preference" or "Prime Line Preference (S-CO, G-
CO or L-CO)" is selected, it is not possible to access any PT features after going off-
hook. To access these PT features, press the INTERCOM (ICM type PT) or PDN (DN
type PT) button before or after going off-hook.
No Line Preference — Outgoing (Assignment)
When you go off-hook to make a call, you are not connected to any line. You must choose the
line.
— Be sure that you are in the Station Programming mode: Press [PROGRAM] [9] [9].
— To exit the Station Programming mode: Press [PROGRAM].
*1
If PT is DN type, then the default is PDN.
PT
Dial 1.
Press STORE.
Dial 1.
11
AUTO DIAL
STORE
The STORE indicator lights.
The display shows the initial
programming mode.
The display shows the current
status.
<PT Display Example>
Pref.Out:No
To Next Page
Loading...
