Station Programming
User Manual 91
Prime Line Preference — Incoming (Assignment)
You are connected to a call on the line assigned as the prime line automatically, when you go
off-hook to answer a call.
— Be sure that you are in the Station Programming mode: Press [PROGRAM] [9] [9].
— To exit the Station Programming mode: Press [PROGRAM].
Note
• If your PT is DN type, then you cannot select "ICM."
PT
Dial 3.Dial 2.
Press STORE.
Press the desired line access
button.
(Selection)
ICM, S-CO, G-CO, L-CO, PDN, SDN
32
AUTO DIAL
STORE
The STORE indicator lights.
The display shows the initial
programming mode.
The display shows the current status.
<PT Display Example>
( When ICM is selected)
Pref.In :ICM
To Next Page
Loading...
