User Programming
User Manual 111
Before entering the User Programming mode
Before entering the User Programming mode, confirm that:
• Your telephone is on-hook, and
• No calls are on hold at your telephone.
Entering the User Programming mode
To enter the User Programming mode:
• The display shows the Initial Message: SYS-PGM NO?
Notes
• If nothing is entered within five seconds after the PROGRAM button is pressed,
programming mode is canceled.
• During the programming mode, your extension is treated as a busy extension.
• Only one Proprietary Telephone can be in programming mode at any one time.
• The User Programming Password is not shown on the display for security reason.
The password can be changed by System Programming.
Programming Guide References
• 10.6 System Parameters
– [Password] User Programming – PT
Press PROGRAM + + + User Programming Password (default:1234)
To Next Page
Loading...
