Panasonic KX-TD500 - Page 141

User Programming
User Manual 141
Programming
Conditions
• There is maximum of eight location numbers (Quick dial 1-8).
A maximum of 24 digits, consisting of 0 through 9, , and # keys, and the FLASH, PAUSE,
SECRET and "-" (hyphen) buttons can be assigned to a quick dial number.
• Before programming this program, a feature number for each location should be
programmed by System Programming <Section 2.3 Numbering Plan in the Programming
Guide>.
Display PT
Dial 009. Enter a location number
(1 through 8).
location no.
<To end:>
Press NEXT.
NEXT
<PT Display> <PT Display>
Location NO?→
To enter location number 1, you
can also press NEXT.
<PT Display Example>
1:Not Stored
Press END.
END
<To continue:> [When SELECT is pressed]
Repeat these steps
Enter a desired number.
desired no.
Press STORE.
Press NEXT or
PREV or SELECT.
Enter the desired
location number
(1 through 8).
location no.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR
and enter the new number.
009
009 QUICK DIAL
NEXT
PREV
SELECT
STORE