Station Features and Operation (PT/SLT)
User Manual 157
Note
• % indicates the digit where you enter the desired parameter.
Canceling the absent message
Conditions
• All nine messages can be programmed either by User or System Programming.
• A maximum of seven parameters ("%" characters) can be stored per message. You can enter
"0 through 9," " " and "#" for the parameters.
•
The message you select is shown on the display of your PT whenever you go off-hook.
• Distinctive Dial Tone
When this feature is assigned to the extension, the extension user may hear a distinctive dial
tone (dial tone 2) after going off-hook depending on System Programming <Section 2.8
System Option, "15. Special dial tone after setting feature" in the Programming Guide>.
• With the KX-T7431, KX-T7433, KX-T7436 or KX-T7235, you can execute this feature
using the display operation.
Programming Guide References
• 2.3 Numbering Plan
– Absent Message Set / Cancel
• 2.8 System Option
– Special dial tone after setting feature
• 5.8 Absent Message
Features Guide References
1.17 Display Features
PT and SLT
Dial 7500.
Confirmation tone
and dial tone
Lift the handset or press
SP-PHONE/MONITOR.
Hang up or press
SP-PHONE/MONITOR.
7 5 0 0
<PT Display Example>
Message Cancel
To Next Page
Loading...
