Station Features and Operation (PT/SLT)
User Manual 209
[Unscreened – To Extension]
• Transfer Recall Destination
If the call (intercom, CO, TIE) transferred to the destination extension is not answered
within a specified period of time <Section 2.5 System Timer, "Transfer Recall Time" in the
Programming Guide>, it may ring an Operator extension instead of the extension who
originally transferred it. This is determined by System Programming <Section 2.8 System
Option, "6. Transfer recall destination" in the Programming Guide>.
• When "Transfer Recall" occurs, the display shows:
<Example>
• Automatic Disconnection
If there is no answer for 30 minutes after "Transfer Recall" starts, the line will be
disconnected.
• Camp-on Transfer
When the transfer destination party is busy, the call is put in waiting status. If the destination
party remains busy or does not answer the call within a specified period of time <Section
2.5 System Timer, "Transfer Recall Time" in the Programming Guide>, the call will ring
back the extension who transferred the call or an Operator extension.
• Remote Administration
Any extension user can transfer a call to the Remote Resource (Modem) for Remote
Administration.
• A CO call can be transferred directly to a Uniform Call Distribution (UCD) group so that
an idle extension is automatically hunted by UCD. If all extensions in a UCD group are
busy, the incoming CO call will be handled by the UCD Time Table.
• During a call transfer to the Remote Resource (Modem), a confirmation tone is not emitted
after dialing the FDN for the Remote Resource.
Programming Guide References
• 2.4 Class of Service (COS)
– Trunk Group Setting
– Transfer to CO
– Automatic Hold
• 2.5 System Timer
– Transfer Recall Time
– CO-to-CO Line Call Duration Time
• 2.8 System Option
– Sound source during transfer
– Transfer recall destination
– Pressing DSS key operation in CO talking
• 4.3 Extension Line
– CO Key
• 4.4 DSS Console
RCL:Ext 1003
To Next Page
Loading...
