Station Features and Operation (PT/SLT)
User Manual 309
Conditions
• Class of Service (COS) Programming
COS programming determines the extensions that can perform this feature.
• By System Programming, you can select either automatic Day/Night mode switching or
manual Day/Night mode switching.
• In the automatic case, the default start/end time for each mode is as follows:
• Day mode – 9:00 a.m.
• Lunch_Start mode – 12:00 p.m., Lunch_End mode – 1:00 p.m.
• Break_Start mode – 3:00 p.m., Break_End mode – 3:30 p.m.
• Night mode – 5:00 p.m.
• Any extension user (with display PT) can confirm the current mode, Day, Night, Lunch or
Break.
• The Manager and the Operator can also switch the Day / Night / Lunch / Break mode.
• You cannot switch the selection mode from Night to Lunch or Break.
• There are 2 types of switching modes: "Auto" and "Manual." The mode is set by the PC
programming or by entering the feature number "Night Mode Set / Cancel" or pressing the
DAY / NIGHT button by allowed extension on a tenant basis.
When the system is in "Auto" mode, the mode will be switched automatically in accordance
with timetable in 2-1 Tenant screen of the PC programming.
When the system is in "Manual" mode, the system keeps the current mode even though the
time to change the mode automatically has arrived.
• If DIL destination is not assigned for Lunch / Break mode, DIL destination performs in Day
mode as usual.
Programming Guide References
• 2.2 Tenant
– DAY / NIGHT Switching Mode
– Alert Extension – Day / Night
– Day (SUN – SAT)
– Night (SUN – SAT)
– Lunch_Start (SUN – SAT)
– Lunch_End (SUN – SAT)
– Break_Start (SUN – SAT)
– Break_End (SUN – SAT)
• 2.3 Numbering Plan
– Night Mode Set / Cancel
• 2.4 Class of Service (COS)
– Switching Day / Night Mode
– TRS Level – Day / Night
– Trunk Group Setting – Day / Night
• 3.2 Trunk Group
To Next Page
Loading...
