Station Programming
72 User Manual
One-Touch Dialing Button (Assignment)
Allows you to assign a Flexible (CO, DSS, PF) button as a One-Touch Dialing button.
— Be sure that you are in the Station Programming mode: Press [PROGRAM] [9] [9].
— To exit the Station Programming mode: Press [PROGRAM].
Conditions
• The number can be an extension number, telephone number or a feature number. Up to 24
digits can be stored in a One-Touch Dialing button.
• To store the telephone number of an outside party, a line access code (9, or 801 through 848)
must be stored as the leading digit.
• You can store a number consisting of 25 digits or more by dividing it and assigning it in two
One-Touch Dialing buttons. In this case, the line access code should be stored in the first
button.
• You can use 0 through 9, , #, PAUSE, FLASH, CONF and INTERCOM for storing.
FLASH: hook flash
PAUSE: pause
CONF: — (hyphen)
INTERCOM: for secret dialing
#: for changing the dialing mode (Pulse to Tone)
• KX-T7220 and KX-T7250 telephones do not have a PAUSE button. The PROGRAM
button can be used instead of the PAUSE button while programming.
PT
Press the desired Flexible
(CO, DSS, PF) button you
wish to assign as a
One-Touch Dialing button.
Dial 2.
Press STORE.
Enter the desired number
(extension number,
phone number, etc.).
desired number
AUTO DIAL
STORE
2
• The STORE indicator lights.
• The display shows the initial
programming mode.
<PT Display Example>
• Up to 24 digits can be stored.
• To erase an incorrect entry, press the CLR (S2) button or the
TRANSFER (CLEAR)button.
(The TRANSFER button becomes the CLEAR button in the
Station Programming mode.)
CLR
To Next Page
Loading...
