possible to set a different ring tone pattern for calls received from each external sensor, to distinguish between
them.
Conditions
• Hardware Requirement:
KX-TDA50: An external sensor and DPH
card
KX-TDA100/KX-TDA200/KX-TDA600: An external sensor, OPB card and EIO card
• Some devices may be unable to communicate correctly with the PBX. Confirm compatibility with the
manufacturer of a device before installing it.
• After a sensor has been activated, the PBX will ignore any further alerts from the same sensor for the
duration specified by a timer. This timer can be set separately for each sensor.
• As long as the previous sensor call is still being performed, any further alerts from the same sensor are
ignored.
• The assigned sensor name and/or number are shown on the display of PTs and PSs when a sensor call
is received.
• If the destination of a sensor call has set FWD, the sensor call will be redirected to the FWD destination.
However, if the FWD destination is not supported as the destination of a sensor call (e.g., an outside party),
the call will be received at the original destination. (® 6.1.6 FWD (Call Forwarding))
• The following features cannot be used when a sensor call is received:
– Alternate Receiving—Voice (® 9.1.13 Intercom Call)
– Hands-free Answerback (® 8.1.1 Hands-free Answerback)
– Consultation Hold/Call Hold (® 3.1.19 Consultation Hold, ® 3.1.2 Call Hold)
– Call Transfer (® 3.1.8 Call Transfer)
– Executive Busy Override (® 5.1.3 Executive Busy Override)
• Sensor call information is output on SMDR.
Installation Manual References
KX-TDA50
2.5.1 DPH4 Card (KX-TDA5161)
2.7.1 Connection of Doorphones, Door Openers, External Sensors, and External Relays
KX-TDA100/KX-TDA200
2.6.1 OPB3 Card (KX-TDA0190)
2.6.3 EIO4 Card (KX-TDA0164)
2.10.1 Connection of Doorphones, Door Openers, External Sensors, and External Relays
KX-TDA600
2.8.1 OPB3 Card (KX-TDA0190)
2.8.3 EIO4 Card (KX-TDA0164)
2.12.1 Connection of Doorphones, Door Openers, External Sensors, and External Relays
PC Programming Manual References
3.27 [1-1] Slot—OPB3 Card Property (KX-TDA100/KX-TDA200/KX-TDA600 only)
→
Input Signal Decision Time
→ Input Signal Detection Reopening Time
3.31 [1-1] Slot—Card Property - DPH type (KX-TDA50 only)
→ For Sensor (EIO)—Input Signal Decision Time
→ For Sensor (EIO)—Input Signal Detection Reopening Time
4.4 [2-3] Timers & Counters—Miscellaneous
—
External Sensor—Ring Duration
4.16 [2-8-3] Ring Tone Patterns—Call from Others— External Sensor—Ring Tone Pattern Plan 1–8
Document Version 2010-11 Feature Manual 103
5.1.9 External Sensor
To Next Page
Loading...
