• When a PS comes within range of a certain PBX, Out of Range status is automatically released. However,
in some negative wireless network conditions, Out of Range status may not be released automatically. In
this case, the PS user can manually release Out of Range status by pressing the Talk key and confirming
that a dial tone can be heard from the PBX.
• If the status of a PS is set to Out of Range at all PBXs that it is registered to, the call will be redirected to
the overflow destination of the ICD Group.
• Handover from one PBX to another PBX during a conversation is not possible.
PC Programming Manual References
4.4 [2-3] Timers & Counters—Miscellaneous—
System Wireless—PS Out of Range Timer
4.17 [2-9] System Options—Option 4— System Wireless—Out of Range Registration
5.12 [3-5-1] Incoming Call Distribution Group
—Group Settings—Main
→
Floating Extension Number
→ Distribution Method
5.13 [3-5-1] Incoming Call Distribution Group
—Group Settings—Member List
PT Programming Manual References
[620] Incoming Call Distribution Group Member
[622] Incoming Call Distribution Group Floating Extension Number
[624] Incoming Call Distribution Group Distribution Method
Feature Manual References
9.1.4 ICD Group Features—Outside Destinations
13.1.18 PRIVATE NETWORK FEATURES—QSIG
Description
QSIG is a protocol which is based on ISDN (Q.931) and offers enhanced PBX features in a private network.
The QSIG network supports private communications by the TIE line service method.
The following features are available for an ISDN-QSIG or VoIP private network. For ISDN, system programming
is required to specify whether each feature (excluding Calling Line Identification Presentation [CLIP]) is
available for each port of the private network.
[Standard Service Table]
Service Description & Reference
Calling Line Identification
Presentation (CLIP)
Sends the caller’s
number to the QSIG network when making a call.
® 13.1.21 Private Network Features—QSIG—CLIP/COLP
(Calling/Connected Line Identification Presentation) and CNIP/
CONP (Calling/Connected Name Identification Presentation)
Connected Line
Identification Presentation
(COLP)
Sends the number of the answered party to the QSIG network when
answering a call.
® 13.1.21 Private Network Features—QSIG—CLIP/COLP
(Calling/Connected Line Identification Presentation) and CNIP/
CONP (Calling/Connected Name Identification Presentation)
256 Feature Manual Document Version 2010-11
13.1.18 PRIVATE NETWORK FEATURES—QSIG
To Next Page
Loading...
