[805] SMDR Incoming Call Printing
Feature Manual References
3.1.8 Call Transfer
3.1.20 COS (Class of Service)
4.1.5 DID (Direct Inward Dialing)
4.1.7 DISA (Direct Inward System Access)
8.1.5 Host PBX Access Code (Access Code to the Telephone Company from a Host PBX)
9.1.3 ICD Group Features—Log-in/Log-out
13.1.13 PRIVATE NETWORK FEATURES
21.1 Capacity of System Resources
16.1.2 Special Carrier Access Code
Description
If the PBX has access to multiple telephone companies, a Special Carrier Access code assigned through
system programming is required every time a CO line call is made without using ARS.
A pause of a preprogrammed length will be automatically inserted between the user
-dialed Special Carrier
Access code and the subsequent digits. (® 13.1.4 Pause Insertion)
Conditions
• TRS
Toll Restriction (TRS) checks only the dialed telephone number excluding the Special Carrier Access code.
(® 17.1.6 TRS (Toll Restriction))
• ARS
A pause is not automatically inserted between the user-dialed access code and the subsequent digits when
ARS mode is enabled. (® 1.1.3 ARS (Automatic Route Selection))
• If this PBX is installed behind an existing host PBX:
A Special Carrier Access code and a Host PBX Access code should be assigned separately—these codes
cannot be assigned together as one code. (® 8.1.5 Host PBX Access Code (Access Code to the
Telephone Company from a Host PBX))
PC Programming Manual References
9.3 [7-3] Special Carrier
PT Programming Manual References
[303] Special Carrier Access Code
Feature Manual References
1.1.3 ARS (Automatic Route Selection)
21.1 Capacity of System Resources
Document Version 2010-11 Feature Manual 293
16.1.2 Special Carrier Access Code
To Next Page
Loading...
