Pattern 11
Pattern 12
ON
OFF
ON
OFF
t=1.28 s
10.24 s 10.24 s 20.48 s
t
t=1.28 s
10.24 s 10.24 s 20.48 s
t
• It is possible to leave a Message Waiting notification while hearing a ringback tone, busy tone, or DND
tone.
• Messages
are always left on the original destination extension, regardless of that extension’s FWD settings.
(® 6.1.6 FWD (Call Forwarding))
• Both the calling extension and the called extension can cancel a notification after it has been left.
• If the extension that received a notification calls back the extension that sent the notification, and the call
is answered, the notification will be cleared automatically. However, if a voice message has been left on
the VPS, whether the notification is cleared or not depends on the VPS settings.
PC Programming Manual References
3.4 [1-1] Slot—Card Property - Extension Type—
SLT Power Supply (KX-TDA100/KX-TDA200/KX-TDA600
only)
4.8 [2-6-1] Numbering Plan
—Main—Features—
Message Waiting Set / Cancel / Call Back
4.10 [2-6-3] Numbering Plan
—B/NA DND Call Feature—
Message Waiting Set
4.17 [2-9] System Options
→Option 3— Dial Tone—Distinctive Dial Tone
→Option 5— SLT—Message Waiting Lamp Pattern (KX-TDA100/KX-TDA200/KX-TDA600 only)
5.21 [3-8-1] VM(DTMF) Group—System Settings— VM DTMF Command—Listening Message
6.1 [4-1-1] Wired Extension—Extension Settings
—Main—
SLT MW Mode (KX-TDA100/KX-TDA200/
KX-TDA600 only)
6.5 [4-1-4] Wired Extension—Flexible Button
—
Type
6.13 [4-2-3] Portable Station—Flexible Button
—
Type
6.18 [4-3] DSS Console— Type
Feature Manual References
6.1.3 Flexible Buttons
21.1 Capacity of System Resources
Operating Manual References
1.3.43 Message Waiting
192 Feature Manual Document Version 2010-11
11.1.3 Message Waiting
To Next Page
Loading...
