Panasonic KX-TDA50 - Page 242

Conditions
• A CO line which is used for a private network should be assigned
"Private" as the networking type. (®
9.1.10 INCOMING CALL FEATURES)
• To establish a QSIG network (® 13.1.18 PRIVATE NETWORK FEATURES—QSIG), each ISDN (QSIG)
connection in a TIE line network must have the port on one PBX assigned as a master port, and the port
on the other PBX assigned as a slave port. PBXs that support this feature are KX-TDA series, KX-TDE
series, and KX-NCP series PBXs.
[TIE Line Network Connection Example]
PBX-1
PBX-3
PBX-2
Extn.1000
:
Extn.1999
Extn. 2000
:
Extn. 2999
(A) Master
(B) Master
(C) Master
QSIG Network
(A) Slave
(C) Slave
(B) Slave
Extn. 3000
:
Extn. 3999
• TIE Line Call by Own PBX Extension Number
TIE line calls can be made using your own PBX extension numbering scheme (1
–64).
PBX-1
TIE Line
PBX-2
InterfaceInterface
Extn.1033
Extn.1011 Extn.1012
TIE Line Network
Outside Caller
CO Line
CO Line
Dials "123-4567".
Telephone Company
Destination: 1033
DID No.: 4567
Dials "1033".
Explanation:
The
PBX first searches local extensions for a matching number. If a dialed number is not found at the local
PBX, the call can then be sent to a remote PBX, and the remote PBX checks the TIE Line Routing Table
for a corresponding entry.
242 Feature Manual Document Version 2010-11
13.1.13 PRIVATE NETWORK FEATURES