Getting Started – Attaching a Lens
62
Removing a Lens
• While pressing the lens release button (B), rotate the lens in the direction of the
arrow until it stops and then remove it.
• When you have attached a lens that does not have a communication function
with this camera, after turning on the camera, a message asking for confirmation
of the lens information is displayed. You can register the focal length for the lens
when you select [Yes]. You can also select from amongst already registered lens
information. ([Lens Information]: 274)
• You can change the settings so that the confirmation message is not displayed:
([Lens Info. Confirmation]: 595)
• Insert the lens straight in.
Inserting this at an angle to attach it may damage the camera lens mount.
• After removing the lens, be sure to attach the body cap and the lens rear cap.
To Next Page
Loading...
Need help?
General
